George recommends using the VELCRO strips provided to wall mount your C O Monitor.
All digital display type C O Monitors or alarms should be mounted “head high or slightly higher” on an inside wall, and if the home has only one C O Monitor, it should be located within 15 feet of the bedroom door. Actually you should have at least one C O Monitor on each “Lived In” Level of your home.
When using the Velcro to mount your C O Monitor, you must remember to clean, [using only a damp cloth], both the flat wall or other vertical surface upon which you intend to mount your C O Monitor; as well as the rear housing surface of the Monitor, being very careful not to get water into the housing of the C O Monitor.
Also, if you are using Velcro or when using your C O Monitor as an “On Person” C O Monitor without the back plate, [as I do], you must personally remember to activate the Monitor manually by moving the “ON/OFF” toggle switch located inside the Vertical slot located in the right rear of the main body of the Monitor housing.
The power supply is activated by lifting the toggle switch arm upward and can be turned OFF by pushing the arm Downward.
Using the Velcro to wall mount your C O Monitor also makes it far easier to take your Monitor off the wall when you want to use it as a portable C O Sensing tool throughout your home or to take it with you when you travel.
ALWAYS BE SURE YOU HAVE REACTIVATED YOUR C O MONITOR AFTER RETURNING IT TO THE WALL MOUNT POSITION BY PUSHING THE TEST BUTTON AND HEARING THE FOUR BEEPS.
19299 Katrina Lane – Eldridge Missouri 65463-9102
Tel: 1-888-443-5377 Fax: 1-888-436-5377